Ezgo Golf Cart Electric Motor Test

The wall socket where you charge it.

Ezgo golf cart electric motor test. Before troubleshooting an ezgo cart controller it is crucial to test the controller. Take a 120 volt tester and use the probes to confirm that there is power reaching the socket. Before you check the motor itself first test the source of the power. If the cart now moves the issue has been resolved.

Turn on the cart s motor and push on the accelerator pedal. The inductive throttle sensor in an ezgo is a part of the electrical system of the golf cart and is connected through a wiring harness to the direction selector. Be certain that the battery is not being charged before you begin working on any ez go electric golf cart. The very first part of it is first to identify the cart drive system.

The its is used along with the cart s electric speed controller like pds dcs and series. Assuming that we re using a multimeter and not just a continuity tester set your tester to the continuity setting and if it doesn t have one set it for ohms. Ezgo golf cart electric motor troubleshooting table for all your electrical motor issues please match the symptoms to the probably cause. This will allow you to correct the problem with your ez go goft cart electric motor.

How to test your golf cart motor for a short begin by labeling the cables going to your electric motor and put a corresponding label on the motor itself if it does not already have one. If no power is produced by the motor however the motor has burned out and must be replaced.